Rich Brown <notifications@github.com> writes:
> Hmmm... The `--test-parameter=ping_hosts=gstatic.com` information
> appears in the command-line summary but not in the charts. Is this
> correct?
>
> If so, the charts display significantly different latency depending on
> which -H host gets used. The Terminal display (bottom) shows fairly
> consistent ping times and transfer rate measurements using either of
> the two hosts.
>
> This raises two questions:
>
> 1. Could flent charts use the `--test-parameter=ping_hosts=...` instead of values from the -H host?
Well, it should probably show both by default. For now, there's a
separate plot type you can use to see the extra flows (-p ping_extra).
> 2. Why is there a discrepency between the
> `--test-parameter=ping_hosts=...` reading (showing 30-38 msec in my
> tests) and a separate, concurrent fping test (see original post, where
> it was running 20-22 msec)?
Good question. IPv4 vs IPv6 maybe?
—
You are receiving this because you are subscribed to this thread.
Reply to this email directly, view it on GitHub, or mute the thread.